Search results

posted in error -please delete post

Couple of years ago my abs light started coming on intermittently. When it failed it's mot I replaced the rear o/s abs sensor - it had to be drilled out due to corrosion on the hub. Honda wanted over £300 for the part but Eurocarparts only wanted £160 so I thought I saved a bit. All was good...

A few weeks on, with a new battery, and the ABS fault light has returned. The exact error readings reported by the garage were: 1. O/S/R SENSOR CIRCUIT? 2. BATERY CHARGE FAULTY After worrying that my old battery was screwed because it wasn't getting a proper charge, I checked the new one today...

Realised my MoT was about to go overdue so went to back street garage for both. They read and reset the fault, it disappeared and didn't return. Fault was o/s rear sensor and battery charge faulty. Garage guy said it's sometimes indicative of a flat battery. So my guess is the battery may be on...

Thanks toffee_pie. Haven't done any work today yet but a thought occurs to me. If the sensor was broken when I knocked the curb then surely I would have got the fault immediately. The sensor code suggests a poor connection to all wheels

Because I have had bad experiences with Honda dealers. On the last occasion they charged £90 for an hours work to tell me that my brake lights worn't worikng (the reason I took it in) but it might be something to do with the tow bar connections. Went to local garage and the guys said something...

So far all I have done is to short the 4 and 9 pins to see if it gives me a response. I'm going to recheck it in the morning The Data Link Connector is, as adivsed above, on the drivers side above the throttle pedal, under the dash immediately beneath the coin tray. This image is the same...

Checked as per the vid in my last post and it works. Difficult to work out the code though. Slow and then quick but each time I count it seems a bit different does it a couple of times then stops. To get it to repeat from the beginning you have to take out the bent paper clip, ignition on then...

Found this for the ODB2 connector http://www.youtube.com/watch?v=oKcwkWsHk98 Not sure if this is the ODB2 connector. The workshop manual refers to a Data Link Connector 16p (16 pin?) in the ABS circuit in that location area. Only 7 of the 16 pins are used, and the pins 4 and 9 in the text to...

Thanks for the quick replies. I guess when you talk about the OBD2 plug its the one with lots of connections. I have seen a youtube vid where a couple of these pins are shorted to produce a code, but it was not the same model as mine. Whereas Eric the car guy is shorting a blue 2 pin connector...

Hi guys. Had a little problem yesterday after I knocked front left wheel against a curb. After a few miles the amber ABS light came on for a short while. Later in the journey it came on and stayed on. I suspect therefore a fault with the front n/s abs sensor From reading various forums it seems...