2.2 I Dtec Torque Damper....Has anyone tried?
- Thread starter samlam34
- Start date
julekasMobilek
Members
Do you meen a dual mass flywheel (DMF)?
No,
Its a mini suspension look device that normally attatches to one side of the front strut brace onto a solid part of the engine to absorb any engine movements under load
an example :
https://www.amazon.com/Ingalls-Engineering-93038-STIFFY-Engine/dp/B001QUEXM4
Its a mini suspension look device that normally attatches to one side of the front strut brace onto a solid part of the engine to absorb any engine movements under load
an example :
https://www.amazon.com/Ingalls-Engineering-93038-STIFFY-Engine/dp/B001QUEXM4
Goodluckmonkey
TA Friends
Sounds like a good way to transmit the noise and vibration back to the cabin that Honda engineered out.
julekasMobilek
Members
So whats the purpose of engine mounts?
Even though... honda engines do not produce that big torque figures (or any at all
), so why do you need this?
Even though... honda engines do not produce that big torque figures (or any at all
), so why do you need this?julekasMobilek
Members
Gosh..., as Goodluckmonkey said, that honda engineered them out (vibration and noise) due to these engine mounts, which a rubber inside (some of them are vacuum controlled) to smooth engine vibration and so on...Ned said:They stop the engine falling out onto the road
And thread creator suggesting/asking if anyone tried that device which in some sort of way disabling the purpose of engine mounts.
Its like a ride a car without springs, just with dampers....
Sorry Julius I misunderstood the point you were making.
It's surprising how changing the setup can effect how the engine runs. The rubber exhaust mounts on a SRI Cavalier I had broke and I needed to use the car before I could get new ones. So I secured the exhaust with heavy duty cable ties. This made the exhaust pipe to rigid and upset the engines balance so every time stopped the engine would stall.
It's surprising how changing the setup can effect how the engine runs. The rubber exhaust mounts on a SRI Cavalier I had broke and I needed to use the car before I could get new ones. So I secured the exhaust with heavy duty cable ties. This made the exhaust pipe to rigid and upset the engines balance so every time stopped the engine would stall.