Hi, mate, I do not know the answer of your question, but I want to add something regarding the change of the rear sensors. If you are changing for the first time you'll probably end up drilling them out. This is not a problem and don't be afraid of doing it, because it is the only option. The problem comes that after drilling there is a chance of the surfaces where the sensor gets in become a bit scored. The accord rear bearing is 100% sealed. The bearing has large o-ring and the sensor too. I had to change both bearings on mine due to damage from water ingress (the water came from the sensor). The solution I have found is to use rtv sealant when installing the abs sensor. Just put the sensor half-way in, put some rtv, slide in and torque.