Recent content by Bosch

Hi antdad Thanks for your time and for the time being I'll run the car without CC and see if the clutch starts slipping. If it does not slip in teh next say 500 miles then I'll adjust the switch A. Will keep you posted. Thanks again

Good morning antdad Thanks for your input and having a spacial car is a pain!!! The reading you wanted: Pedal Position Switch Voltage At top without any pressure applied A 0 At top without any pressure applied B 12 Fully pressed to bottom A 12 Fully pressed to bottom...

Hi antdad I managed to look at my car today and there are two switches fitted on the clutch pedal, as perthe attached picture. My apologies for the rough drawing but it should help with whats happening with the switches. I think if there is a fault with the switches its switch A which could be...

Hi antdad, thank for coming back to me and I have tried everything i know to download the manual but without luck. Anyway, SE i-CTDI is what's on the log book and its a 4 door saloon and it has two switches on the clutch pedal. Depending on the weather tomorrow, I will try and check them for...

Thanks for your help antdad, My car is SE i-CTDI, it was registered in April 2008 but it will have been imported in 2007. There are two switches on the clutch pedal, if that helps!

Hi antdad sorry can't seem to download the manual. Is it possible to accach it to the thread?

Thank you antdad and I'll check the switches and get back to you. Thanks again.

I have read most of the forums and it looks fairly simple job to change the clutch but just like to tell you about my issues and seek advice on setting cruise control switches located on the clutch pedal and pressure plate. I have a 2008 Accord Diesel and its done 92K without any problems but...