Search results

  1. A

    Parking Sensor Issue

    Thanks all Had a look one evening, I took the bumper off. Was able to find the faulty sensor by moving it to a different position. Have managed to get a spare from a breaker, correct colour too,
  2. A

    Parking Sensor Issue

    Thanks for the reply, I have cleaned them, still the same I will probably have to remove the bumper at some point to look at them. Do you know if they are disconnected one by one, will it display problems as a result of them being disconnected? Hopefully by doing this, I will be able to...
  3. A

    Parking Sensor Issue

    Hello all My rear parking sensors seem to be faulty. When in reverse with the sensors turned on, they alarm is constantly sounding, even when not near anything. What may be the cause of this and how would I trouble shoot? Disconnect sensors one at a time? Thanks
  4. A

    EPS warning light

    Just to update this, it was the yaw rate sensor that was at fault
  5. A

    EPS warning light

    Hi F6HAD, I have an autel code reader, which I connected, and there are no codes present. Would you think this may not read all codes, or if there was a code present for EPS should any OBD2 reader display it?
  6. A

    EPS warning light

    Hi, I have the EPS warning light/indicator on permanently on my accord (2008 idtec) What might cause this? Is it a job for honda HDS?
  7. A

    Handbrake adjustment

    Yes, adjusted the shoes
  8. A

    Handbrake adjustment

    Hello Do you know how much thread is on the adjuster cable below central arm rest I can tighten so far, but gets to a point where can’t get it to go further, it may be that I can’t get enough of movement with spanner at this point about 10mm thread exposed
  9. A

    Air con compressor

    Are there compressors other than genuine honda 38810-RL0-G01 available for the 8th gen?
  10. A

    air con

    Hello, how do you open the inbuilt diagnostics again?
  11. A

    DPF replacement, how much work?

    DPF light has come on, Considering what ill do with it. Removal, if removed is there reprogramming of ecu required, Reconditioned unit - have seen a few companies offering a cleaning service, some form of ultrasonic cleaning process, dont know how effective, any one have experience of this? I...
  12. A

    DPF replacement, how much work?

    I haven't it since new, my only thinking on it still being there is the there is no soot in the exhaust pipe? If the dpf was removed, would there be soot evident in the exhaust pipe? Ya i suppose cant say for definite then prior to me getting it if was changed, but around 76000 on it when i got it.
  13. A

    DPF replacement, how much work?

    Im at 147000 miles on my car, and still original DPF. Something i have never noticed is it actually completing a regeneration cycle, maybe this wouldn't be obvious?
  14. A

    Towbar wiring

    I ran power direct from the battery, with a fuse in the line. All i didnt do was make a connection into the fog lamp feed. the fog lamp is in the bootlid, but im hoping it should be possible to get this from cabling in the side panels rather than having to go into boot lid
  15. A

    Towbar wiring

    Just fitted a towbar and have to wire in bypass relay. Can the 12v be taken from a point in the fuse box or must this come direct from the battery?
  16. A

    Fuel rail pressure too low - 8th gen iDTEC EX Saloon

    From Honda its part of the pump. The garage i had it with is a bosch service centre, the valve was sourced from Bosch. I dont have a part number but it should be on the valve itself. There available on ebay
  17. A

    Fuel rail pressure too low - 8th gen iDTEC EX Saloon

    Just to add closure to this issue with my car. P0087 fault code. It was the metering valve on fuel pump. I had this replaced about a couple of months ago.
  18. A

    Fuel rail pressure too low - 8th gen iDTEC EX Saloon

    Is that for me or the original poster? If for me, then regarding the EML, no, How do you know if i have or haven't changed the filter? I only inquired about a part number.
  19. A

    Fuel rail pressure too low - 8th gen iDTEC EX Saloon

    Would you have a part number for the pressure sensor?
  20. A

    Rear Coil spring replacement

    I wonder would the broken spring effect the alignment. When i first got the car aligned after buying it, the camber was out on this side. I bought adjustable arms to correct. All was ok for a while and the tyres started wearing on the inside, so i got it aligned again, only to be told that they...
Top