Dan Robinson
Grand High Plumber
Got my EBC grooved brakes and green stuff pads this morning.
Spent a couple of hours this afternoon changing them. This is the first time I have done this to a car so was a bit nervous - but thanks to our custom google search and alnugs write up it went OK.
Now some of you may notice in the secong photo a little discolouration. Also, when i went for a little test drive, I did a moderate brtake from 60 to 0 into a layby and there was a nasty smoke coming from the offside. I forgot to check the nearside, but I am pretty sure the pads were binding. Now I will try and look into this some more tomorrow, but need to drvie to the quack down the motorway in the morning so will give it another gentle test. I am hoping it is just beddign in smoke and that there isn't a problem.
Everything seemed pretty clean on all the moving parts and there was no visible damage to the break lines. The brake fluid is looking a little "tea" like. B|ut I have a new eazibleed thingy delivered this week so again, when time permits I will change that too.
Hardest part of the whole job was pushing the piston back, and getting the inside pad into the carrier properly - I hope I got it right :lol:
first one took 90 minutes - altyough I was again distracted by the dude, and the complete disapearance of my copper grease. I hads to pinch some off my neighbour.
Second one (offside) only took 20 minutes or so - but then i supopose that is par for the course. No bolts or screws were difficult to undo ,and everythngi was nicely torqued up at the end.
Spent a couple of hours this afternoon changing them. This is the first time I have done this to a car so was a bit nervous - but thanks to our custom google search and alnugs write up it went OK.
![IMAG0096.jpg](https://lh5.googleusercontent.com/-Jx1QIkp2q78/TkVut_0cFdI/AAAAAAAABmQ/Ko1ejYa58RY/s800/IMAG0096.jpg)
![IMAG0097.jpg](https://lh5.googleusercontent.com/-T2NtGxRvmKU/TkVulv6hzeI/AAAAAAAABmM/EAzHf6LI5vw/s512/IMAG0097.jpg)
Now some of you may notice in the secong photo a little discolouration. Also, when i went for a little test drive, I did a moderate brtake from 60 to 0 into a layby and there was a nasty smoke coming from the offside. I forgot to check the nearside, but I am pretty sure the pads were binding. Now I will try and look into this some more tomorrow, but need to drvie to the quack down the motorway in the morning so will give it another gentle test. I am hoping it is just beddign in smoke and that there isn't a problem.
Everything seemed pretty clean on all the moving parts and there was no visible damage to the break lines. The brake fluid is looking a little "tea" like. B|ut I have a new eazibleed thingy delivered this week so again, when time permits I will change that too.
Hardest part of the whole job was pushing the piston back, and getting the inside pad into the carrier properly - I hope I got it right :lol:
first one took 90 minutes - altyough I was again distracted by the dude, and the complete disapearance of my copper grease. I hads to pinch some off my neighbour.
Second one (offside) only took 20 minutes or so - but then i supopose that is par for the course. No bolts or screws were difficult to undo ,and everythngi was nicely torqued up at the end.