I cant believe this happened. My near side dip beam was out. The ulb looked ok so thought i would try it in the off side. No joy. Whilst re fitting good bulbit slipped from my fingers and dropped onto the black plastic cowling that the weather seal screws into. Whilst retrieving this i pushed it over the front edge and into oblivion in the headlamp unit. So instead of needing one bulb i now needed two. Off to Wilkos.
Fitted near side no problem. On to the off side. Dropped new bulb again only for it to roll, even with the flat side on the bulb shroud, all the way into oblivion again!!!
So now i need another bulb as well as time spent removing the unit in order to shake out two H1 bulbs!
So my question is regarding removing the headlamp unit entirely. Easy? Hope not to repeat my sausage finger act on anything soon!
Cheers.
Fitted near side no problem. On to the off side. Dropped new bulb again only for it to roll, even with the flat side on the bulb shroud, all the way into oblivion again!!!
So now i need another bulb as well as time spent removing the unit in order to shake out two H1 bulbs!
So my question is regarding removing the headlamp unit entirely. Easy? Hope not to repeat my sausage finger act on anything soon!
Cheers.