Search results

Can be if you have tools, I would say you might as well do chains, tensioner and guides as well as water pump. Sent from my LG-K100 using Tapatalk

The k20 and k24 engines do suffer from slight oil consumption, grade of oil is an issue I recommend 0w30 or 5w30. Next check would be pcv and after that could be a combination of stem seals, piston ring or both. Both will be a strip down and if you are gonna go down that route then you may as...

Check all wiring to make sure something did not get disconnected Sent from my LG-K100 using Tapatalk

Try breakerslink.co.uk for secondhand spares may find good deal Sent from my LG-K100 using Tapatalk

You may have had modified unit installed ? Also your clutch pressure plate must have been in good condition Sent from my LG-K100 using Tapatalk

Perfect thanks for update and pic am sure will help others Sent from my LG-K100 using Tapatalk

Not sure I'm sure part number is same for cmc Sent from my LG-K100 using Tapatalk

agreed it shows 1.9 - 2.2l in wow software

i remeber a bulletin for condensation im sure fix was to place silica bags into headlamp unit, have heard some people have remove them place in oven to remove seal and then re sealed

good points fahad the only thing i would add is throttle body clean as well.

sort out bits overdue on car

im using bosch and they glue to windscreen the force of air keeps them pressed onto screen lets just say i ahve used at high speds without an issue. Not going to declare speeds here

just a follow up on the dreaded clutch master cylinder whilst grease is temporary fix i have upgrade to k tuned clutch master cylinder, slave cylinder with braided hose and not looked back. Read article from k tuned below: The DC5, EP3 and CL9 all have a known issue with their factory clutch...

yes sounds like 5th gear synchro has got damaged the part itself is only a few pounds however labour will around £200 mark so in theory strip and rebuild would be about £250 mark you can buy synchro from honda or htune.

did you get this sorted ?

Had to reserect this old topic to give correct advice, to adjust washer jets, use a small flat screwdriver to adjust angle up or down do not twist or turn screwdriver as this will damage jets and most likely mean a replacement needs to be fitted, To replace passenger side remove 2 clips and flip...

I have seen some shocks that can adjust to loads if I remember right they were air ones, should I just contact major shock manufacturers like eibach, Monroe ? Any others let me know thanks Sent from my LG-K100 using Tapatalk

Will do that and more Sent from my LG-K100 using Tapatalk

Yes I doubt seller knows what it can do, I use this type https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F253475436115 Have tried everything except programming of keys and immobilizer which some say works and some say bit flaky. Sent from my LG-K100 using...

Need some advice in subject I am not too clued up on, I have tourer 03 and use for work, as I carry heavy load of tools with makes back look lowered. I wanted to update suspension so that when I place heavy loads the car will not drop also lower front and rear at same time would be a bonus is...