Search results

Is yours a saloon or tourer ? Not that I have looked closely at the preamplifiewr inside my vehicle, but there is a thread on the site which can be found by searching for 'diversity', the method of getting the signals out of a glass embedded with wires as Honda intended. You shoud find there...

I did not need to resort to 'engine management' to remoive after soaking in cola. The injectors were tight but not impossible to twist slightly then remove. If you are thinking of it then put a few wet towels on top of the cylinder head before firing up.

Unless you get a serious drop in the MPG I would ignore it. Otherwise it is a can of cola overnight, and an hour to check the corrosion on the head surface once out to see if a copper seal will fix it. Then there is the injector cleaning (scraping the stuff off the sides), re-fitting the...

The preferred solvent (as recommended by others) is Coca Cola. I poured the best part of a can whilst hot - into the canal a couple of days before taking things apart and all went fine. There is a difference between leaking injectors and leaking seals so be careful as to the fault and...

Of course, as soon as the weather gets a bit more pleasant the heater matrix starts throwing out hot air....

It would be interesting if there was a claim that fumes from a standard, serviced vehicle were in part responsible for a crash.

Just returning to this. One MOT failure owing to pads (meat left) and an advisory on the disc thickness. The current distance between the pads is a shade over 25mm at centre point with the verniers and there is at least 3mm left on the pad with the most wear, which has not started any grinding...

Are you putting on weight ? Have you got a wife (that is putting on weight) ?

I got my bottle from Holdcroft via ebay. https://www.ebay.co.uk/str/holdcroftmotorgroup

I wouldn't, Honda is not on the list https://www.nationwidefuels.co.uk/faq/what-is-hvo-fuel-an-faq/#can_my_vehicle_run_on_hvo_fuel

I have the Mk7, the thermostat has no bleed on either side of the container (at least on the i-ctdi). I've had to glue it shut anyway as one of the retaining bolts had sheared off.

Is the thermostat functional at the specified temperature ? It may be worth testing in a pan of hot water. Bleeding the system after flushing /refilling is just as important on the Mk7 diesel. I have found that stuff always remains in the matrix, but letting off the radiator cap after the...

I have had to replace the air conditioner radiator on a Mercedes before, horrible experience. The Tourer engine rad is a doddle.

Just how noticeable is the sound inside the cabin ? If you have gone to the trouble of changing the flywheel then I would go and have a look at the exhaust and perhaps a failure of the one of the baffles.

Holy Batman! On a first inspection it looks terminal and odd as I have nothing like that here. It does look like the original treatment by the factory has been removed, why is only known to the previous owners. Is the offside subframe anywhere near as bad ?

Really ? The Tourer here has no problematic corrosion and rust (apart from surface stuff on the bonnet) is negligible Has the K24 spent time near the coast ?

I've not had another incident, though I have a slipping clutch and my driving adjustments mean I rarely have to 'floor it'.

You could try strapping a mobile phone with a voice recorder app under the bonnet and move it around to locate the noise.

For MOT passing on the Tourer (I-ctdi) I use a bit of Solvol autosol. Rub as hard as possible keeping the same bit of towel. Then buff off with one half of the other side, folding over until the debris and damaged plastic is clear of the panel.

I was able to get to the pipes through the front wheel arch skirt, the pumps are underneath the reservoir and just about accessible.