Search results

you do not need disassemble the unit that's for sure ;)

when you lock drivers door first, does passenger doors lock? i believe there may be broken wire in wire harness from door.

i used switch from rover 600. whole steering column is the same :-)

there were diy about stereo removal from our accords.try to searh for it in this forum. in short: you need to remove plastic panel from arround dash and stereo(3screws) then 4 screws to remove stereo and climate control units.bulb type is correct. it is called "T5"

i would suggest you to change gearbox oil,brake,power steering and cooling fluids, if never done this before;-)

It is possible to take knock sensor from any honda what has 1pin conector. I had rover swaped h22a. used sensor from CRV 2.0L(european crv was most current car than jdm prelude :) ). worked perfectly. I believe it would work for this engine too.If there is any scrapyard it is worth to try to...

you need not only fuel pipe, you need brake pipes too.i believe they are rusty like fuel pipe and will start leaking as soon as you will try to take fuel pipe out.

here is very good video on vtec testing on 6gen accord http://www.youtube.com/watch?v=vTis29MQC4U

you can check error shorting 2 pin blue connector under glovebox and reading what check engine light will blink after you turn on ignition. check here. you will find location image http://typeaccord.co...elf-diagnostic/ or here for instructions and code definition...

have you tried turn of flashlube? I don't like how engine is working with it on petrol too.Finally after 3 years of using flashlube i deistalled it completely, as I think it is total nonsense to lure peoples money. I have checked spark plugs and oxygen sensor before and after deinstalling...

if fuses are ok, then turn on ignition and fan at max, take multimeter and check for voltage at motor side of harness, (under glovebox). Then you will know if it is power supply or motor fault. Have you climate control on your car? if yes, then you can run self diagnostic on it too...

actually. when i run these tires I see actual speed on my speedometer. When you run stock 195/60r15 your speedo shows a little more than actually you are going. True story tested with GPS. I use this http://www.rimsntires.com/specs.jsp calculator as it is more friendly. Shows what Tyre is best...

i have 17" ET40(offset) 7j(wideness) alloys on my car with 225/45 tires. Tyre goes by couple mm from fender. p.s. I have noticed that dunlop tires are wider than others with same dimmensions

It believe it is compatible with 4 cylinders engine. you just need 4 injectors fuel rail.

if your handbrake is stuck you may need to change cylinder in brake caliper. they become rusty inside over time if driving with overused brake pads.

It is worth to check valve clearance too. I feel like driving new car after I have adjusted valve clearances to my car :rolleyes: they were to small. valve clearances for f20b6: in-0.1"; ex-0.12"

1.8 has different oxygen sensor than f20b6. If you planning drive this accord for few years Don't buy used one. I read somewhere that this oxygen sensor ( it is not usual oxygen sensor. it is LAF -linear air-fuel sensor) And it is usable only for 150'000km ~ 100'000 miles.

steering column is the same. I have changed my ignition switch electric part from Rover 600. And I have alloys from it too :)

you need to reset srs if you want light to go off procedure is below

:D:D:D unbelievable... 2 redrook this picture is just sample where to look for screws clips. Ig you have no skirts then just ignore them in picture. At last You should look for clips above and below bumper and for 2 (or 4) screws near rear wheel... its so simple. take off what you can find and...