Recent content by StefaTGM

I still haven't fixed the issue, but I have been reading on the internet a lot and there are a lot of ppl with the same problem. uploading the same boost spike and drop and raise, definitely the same boost curve. Could there be a safety feature that will limit boost to save a clutch? I'm not...

Fahad i wish i m close but i am from Balkan few thousand miles away. I have tested it without air filter and nothing changed still boost drop, where would be a intake runner control or where should i check blocked inlet?

I didnt change air filter but to me looks ok i can taks pics of it. Should I try without air filter maybe? What i noticed is lose clip on the bonet cover up next to air intake pipe so i put new clip in and its holding good now i have to test it. The air intake ia standard as far as i can tell...

Hello, When I bought the car I had this strange issue when accelerating with the car, it would accelerate great at the beginning and then it would kind of stop and pick up again. I installed the Torque app and decided to measure boost and RPM i am not sure if any of this is correct with the...

Yep thats what i did with cooper, i dont think it was Bosch but it was around 3.5€ for one cooper. Probably i will take them off all four and send to specialist to check and repair them, i m just not sure if they will need coding after repair.

Hey yes i have cleaned it very well made it shine on the head, cleaned the injector where the washer seats i preheated copper, cleaned the hole and threads for claping injector bolt and torqued to spec, no blow from them, they might just be one of them faulty or might need coding. Milege on car...

Hi fahad thanks for reply, i replaced washers on first and second injector they blew in like first month of owning car, there is no blow by on any injector. Do you maybe know if Delphi ds150 clone can do injector optimisation? or it must be Honda HDS?

Hello, so when i bought the car few months ago i had from the start a ticking injector when accelerating, the seller told me he repaired 2 of them, 3 and 4 but when my brother connected it with diagnostics the 3 injector was off a lot, could it be problem with the first two not repaired or maybe...

I have located an oil leak behind the engine under the turbo feed line, I took a picture of it, I'm not 100% sure it's from here but when I clean it, go for a short drive, and come back I can see oil dripping from the bolt. Can someone tell me if I can unbolt this screw and put a sealant or...

Cracked Exhaust manifold?

I only took this photo while working on it I removed glow box, blower motor, plastic from ac condensor, ac condensor as well and then few plasitc around pipes and unpluged the pipes using flat head screwdriver and pulled out core, cleaned it and put it back in as well cleaned the pipes you can...

Just installed the heat core and heat works now! It was full of sludge took me a long time to clean it Long story short I pulled the heat core without removing the dash, disasembled pipes from it cleaned it and reassembled all back

Yeah i could just of done that, but it would really take time. I have removed it and even now is hard to get it unclogged. Any suggestions on what could try i to remove the sludge inside?

Hello, thanks for reply i have no codes related to that, but i have removed ac condenser and was able to check heat of the heat core when car is warm and so it IS A HEAT CORE. it got cloged the driver side is cold and passenger side is hot. I managed to remove the heat core without pulling the...

Hello, just got Accord recently and heat doesn't work on driver side, i have been reading posts and fixes but none of them worked for me . (Passenger side heat works) • I have checked the valve under the hood and it works fine. (It closes and opens by wire normally from driver blend motor i also...