Search results

Does the diagnostic codes indicate if the compressor is working?, i cannot hear any audible change in engine load between ac on and ac off?

Hi, thanks for the follow up, i did, replaced both. There is a little panel that clips out to allow access to the top of the shock once the seat back is let down

Hello, has any of you replaced the coil springs on an 8th gen, would there be any guides in doing so, more so relating to removing the nuts at the top, does the parcel shelf have to be removed partly and the support/Seat back next the side of the car, the piece on which the seat belt rests

Hello, Firstly i will give a bit of background, i bought my car to get the alignment done, they tried adjusting the toe arm on one side at the back, however they couldn't set it . They advised that it was the bush in the arm, that was gone. Ive had the arm out since, and the bush looks ok, what...

Just dawned on me now, what the purpose is, its the same caliper housing both sides, but bleed screw needs to be moved, so as to have on the upper side

Received my calipers today, and i have brake hoses on order from my local parts store, hope to complete tomorrow evening. On the calliper what is the purpose of the hexagonal piece approx. 15mm long, opposite the bleed screw? One of the new calipers doesn't have this, however has the correct...

Cox are now selling a spurious filter removal tool https://www.coxmotorparts.co.uk/honda-shop/cox-motor-parts-i-dtec-fuel-filter-removal-tool/ I ***ume it should work ok, the genuine one is a bit on the expensive side

Thanks, when fitting the pads i do file, only until a snug fit, so may give them more so that they are looser, because at the minute when i go to remove they do be stuck slightly in the carrier. No matter what grease i put on the pins, they always seem to set in one position, not that they cant...

All points taken on board, i only questioned why, as i genuinely didn't know, not to criticize your point. When you say loose bits of matter, is this in the form of rust, rubber? In the one which is sticking, the side of the piston is corroded, do you think this would be caused by dirt, etc? i...

Why would they cause issue?

Just ordered off brakeparts,

Thanks for the replies Looking at Big Redd website they dont stock the ones i need, however on another site brakeparts.co.uk i think have the correct ones, the only thing i see is the OE manufacturer is listed as Nisshinbo, i wonder is this the same as Nisin...

Hello all and happy new year. I have a sticking rear caliper, i previously replaced seals and pistons, however the problem is back again, (less than one year) the piston is corroded at one point. I will admit i didn't use a genuine Honda piston, whether or not this is the reason for failure or...

Sorry, forgot that one, not included, i didn't change that one,

Yes, all comes with the filter

When trying to bleed air from the system as per above, when the fan comes on, is the thermostat open at that time, If there was air in it and it was ran, would this do harm? What i am seeing is the fans are coming on when the heating is turned on, and go off when i turn the heating off, If...

To provide an update, i bought the repair kit from holdcroft honda, and fitted on saturday, not too bad of a job, small bit of ripping and had to drain the coolant. Fahad, you may know or have seen, do these pipes ever block with soot on cars, the one i removed only had a light coating of black...

Thanks I've seen that service bulletin, however I'm outside the time limit, my car is November 2008, I had no luck in looking for the sunroof recall so I doubt if this will cover me

Hello I think this is cracked/leaking on my car, I will look tonight, there is exhaust fumes at the front of car and in cabin, not bad, Is it a difficult job to replace? I was looking last night but could only see a pipe on the drivers side of the engine at the back which resembles the egr...

Can you not claim the value of the repair off the other persons insurance? If its fixable, say your not writing it off?