Search results

I would like to perform a fuel pressure test but am having trouble locating the schrader valve to attach a pressure gauge. Below is a link to a few photos of what I think may be the correct valve, based on the location of the pipe and where it goes. One is marked "1" in red and has an "L" on...

I need the part (a rubber dust seal) highlighted in red in the images below. I have been through all parts diagrams for engine and transmission here but can't find the part I need. The closest thing (in proximity) I can find is part number 24479PPP000. This is highlighted blue in the images...

I'm planning on putting my 8th Gen Accord on track. Simple yet loaded question: excluding general preparations that all cars should go through (example), are there any 8th-gen-specific preparations to do / problems to know about?

The manual for my 8th Gen 2.0L requires IZFR6K11NS but I can only find IZFR6K11S online which are available in the UK (and a few fake NGK spark plugs as well). I have researched the difference and understand that IZFR6K11NS is a non-resistor plug while IZFR6K11S is a resistor plug. My...

The front bumper splitter on my CU1 ES-GT doesn't seem to be properly attached. See attached photos and video (apologies for low res - there is a limit on this forum). Video: Droop / sag In the video, you can see that the splitter seems to bow on the sides if you push it up in the middle...

see question at bottom to avoid the rambling... i worked out what combinations of width and offset i can put on my 2009 honda accord (european market) which will fit in the wheel arch. i noticed that the offset required to maintain the outbound position as close as possible to stock (to...