I really should take a video of everything I do....
Ok, the bleeder screw is on the end of the slave cylinder. This is located toward the front of the car on the right. It's between the radiator and the top of the gearbox.
The flush procedure is as follows:
1. Extract most of the old fluid from the reservoir using a syringe of similar
2. Add fresh fluid
3. Attach some tubing and an 8mm socket spanner to the bleed nipple
4. With someone in the car, open the bleed nut,
5. get them to press the clutch about 3/4 way down,
6. close the nipple and pull the clutch pedal up
7. Repeat 4-6 about 20 times until the fluid run clean
This takes about 15 minutes of effort and you'll need about 500ml for a flull flush.