2 days ago the alarm went crazy at work, so I disconnected the siren cable to shut it up, and then pulled the Bluetooth module. Both still disconnected of course.
I checked the charge of the battery yesterday, it was around 90% according to my charger, so I let it do its thing and it was done after 10 minutes.
(I drive near 130 miles a day, so expected it to charged reasonably after the alarm/bt thing).
Then about 10 seconds away from work this morning the abs flickered on when I was driving in a straight line about 25mph.
I ran a diagnostic test on it, and had a couple of errors:
P16A4
61-01 Battery Voltage Failure
B1029 BCM & AC (lost communication with ultrasonic unit)
A couple of hours later I thought I'd go and clear the codes, went to fire up the car and it didn't have enough power to start up, crank but not start.
Once again gave the battery a little boost (note its 3 week old battery Lion from ECP).
I just ran the diagnostic test again and this time it only showed the P16A4, so I cleared it this time. Started it up, and rescanned, no errors.
I've unplugged a Bluetooth fm thing I use just in case that's causing a problem.
Not sure really what to make of it all!
Any wisdom would be greatly appreciated.
I checked the charge of the battery yesterday, it was around 90% according to my charger, so I let it do its thing and it was done after 10 minutes.
(I drive near 130 miles a day, so expected it to charged reasonably after the alarm/bt thing).
Then about 10 seconds away from work this morning the abs flickered on when I was driving in a straight line about 25mph.
I ran a diagnostic test on it, and had a couple of errors:
P16A4
61-01 Battery Voltage Failure
B1029 BCM & AC (lost communication with ultrasonic unit)
A couple of hours later I thought I'd go and clear the codes, went to fire up the car and it didn't have enough power to start up, crank but not start.
Once again gave the battery a little boost (note its 3 week old battery Lion from ECP).
I just ran the diagnostic test again and this time it only showed the P16A4, so I cleared it this time. Started it up, and rescanned, no errors.
I've unplugged a Bluetooth fm thing I use just in case that's causing a problem.
Not sure really what to make of it all!
Any wisdom would be greatly appreciated.