Latest activity
-
CHi all :)) I'm super ****ed again at those fuc.... headlights The Xenon Bulb again died and i decided to change them with LED D2S ...
-
I'm planning on putting my 8th Gen Accord on track. Simple yet loaded question: excluding general preparations that all cars should go... -
Order a set from Cox Motors, they will be able to recommend if not these...
-
RedCloud replied to the thread NGK IZFR6K11S vs IZFR6K11NS.Thanks I managed to find the current ones using the part number on their website. Obviously I didn't look hard enough!
-
CChannel Hopper replied to the thread NGK IZFR6K11S vs IZFR6K11NS.Order a set from Cox Motors, they will be able to recommend if not these...
-
RedCloud replied to the thread new Accord.Mine supports Bluetooth but only for handsfree (i.e. phone calls). Set it up with this guide: I have a Bluetooth device plugged into...
-
The manual for my 8th Gen 2.0L requires IZFR6K11NS but I can only find IZFR6K11S online which are available in the UK (and a few fake...
-
F6HAD replied to the thread 8th Gen DIY: i-DTEC Manual Gearbox Oil Change.Don’t put any flushes through it, just stick to a normal fluid change with genuine MTF3. -
F6HAD replied to the thread Was this a good buy?.If the engine is cold then possibly a sticking egr valve (try temporarily blanking egr). If engine is warm then likely a bad fuel...
-
ANZACTinHat reacted to Antsah's post in the thread DIY 8th Gen iDtec Diesel Fuel Filter Change with
Like.
89mm 15flute Oil filter wrench fits perfectly to filter cap. Like this... -
ANZACTinHat reacted to apintofmild's post in the thread 8th Gen DIY: i-DTEC Manual Gearbox Oil Change with Like.
Owing to recent changes in Photobucket’s image hosting service some of the information contained in this thread may have been lost. ...
-
ANZACTinHat replied to the thread 8th Gen DIY: i-DTEC Manual Gearbox Oil Change.Just done my second oil change following your fabulous guides and this is next as I got the car around 134,000 and now it is on 168,000...
-
Rrob88 replied to the thread Was this a good buy?.Sorry to hear this, definitely have a look at fuel filter. Scan the forum I'm sure the problem will be covered or at least help. I...
-
Richard B replied to the thread Full Beam stays on.I would much rather have found a simple, replaceable set of relays. I hope u/chesjak at least finds some simple through-hole board... -
Richard B replied to the thread Was this a good buy?.Can you check fault codes? If it's not a broken sensor, the main thing to check is fuel delivery. I'm looking for an intact right...