Recent content by krism

Hi Part number is 57470-SEA-013. I picked up a pattern part on ebay and its worked fine for 2years. It will probably snap off so try releasing fluid. Be prepared to drill it out or you could remove the bearing ***embly and knock it out. I used a 90degree drill head to get in at it. Cheers

Very late response to your problem but i had the exact same and it was a rear abs sensor. Use a multimeter and check the resistence of all the sensors. The one which is different to the rest is the cause.

Accord TypeS mk7 2003 This guide may be appropriate to anyone with the Sport front splitter. I have had a cracked fog lamp glass for years and decided to do something about it. Removed the lights from the car and my plans to refurbish were abandoned. The lamp itself was rotten. New ones were...

Hi All, My exhaust broke today, where the oval splits in two. Not enough meat on the pipe to weld it. Is Holdcroft Honda quite good for this price of £283 for the cat-back system? Cheers Kris

Do your indicators flash when locking/unlocking?

Hoping I am not teaching you to suck eggs here but a wee tip for getting the old standard ones off. Chisel the white plastic rivets off the back and you will find they will then knock off with ablow of a hammer. Cut the plastic off the ball and then get a pair of vice grips on there.

Update to close this thread :) Last night I eventually found time to fit the new sensor. I first plugged it in and checked the lights went out. Removed the 10mm bolt that holds the sensor, and as it was seized in solid i prised the bracket off the sensor to snap it then cut the wires within...

Possible air getting in system, bad seal at either the mc or sc. Replace pipe for a few pound, fill and bleed a couple of times. If it was the clutch itself it wouldnt go away

ok, so after carrying out the above tests and breaking the abs sensor housing.. the lights have gone off! ABS is working as is the VSA. New sensor enroute and will still need fitting but thats just weird

okay just tested my sensors. front o/s, n/s and rear o/s all give a reading between 33.9-34.4 kohm rear nearside is barely giving any reading so an open circuit i would think and a duff sensor. Unbolted it and tried to get it out, it is siezed solid so will need drilling. Will post if the new...

OBD2 codes are normally in the format of P1234 etc. I believe from reading on this site that VSA/ABS codes can only be read by the Honda Data System as they are manufacturer dependant. Maybe why you have some random codes there?! I have an open thread due to a similar issue. I read the codes...

Thanks for the link. Unfortunately they don't post to the Highlands so I will take a chance with the other seller. Have not had a chance to check the abs sensors resistence due to the weather but hope to get it done tomorrow night. Has anyone checked the ohm reading of a working/broken sensor...

Thanks Peter. Wouldn't be an ebay shop called PartsLondon you used? If not could you tell me which as if it worked for you i will buy from the same place :)

Did some digging about on the Interweb and found a codes list on an Acura TSX forum 12 - Right Front Wheel Sensor 17 - Left Rear Wheel Sensor Going to compare the resistance of this sensors to the two others and see if its faulty. Strangely 61 is listed as low ignition?! Maybe a saved code...

Hello All, I apologise if this information is located on the site, i have used search but not finding it i'm afraid. abs/vsa lights came on last week and have failed to go off. Paperclip trick gave the following codes: 61 17 12 I can't find a list of codes to know whats what, [i don't know...