Search results

Thanks, I will look into getting those

Thanks, Was yours a uk car originally, I'm in Ireland, I think I should contact Honda ireland?

Hi, My accord falls within the range of those vins, it a 2008 , however at honda dealer and on lings it is displayed as a 2009 model. It was registered november 2008,so 7 year limit was november 2015 i wonder what are my chances of getting this replaced. My ***umption would be that the rust...

Hi Brett, Thanks for those, does the ball joint allow for camber adjustment and the arm for toe. Im asking this as i thought the toe was adjustable? For information, in your opinion what causes the camber to be out of spec, is it gradual wear of bushes? Will that ball joint fit into the Honda...

Thanks, Have you any pictures of these components,

Thanks,be great if it's only gas that is needed,I must get this checked out,we have another car here too which also needs gas

I done this and there are two extra measurements. Results as follows at two temperature setpoints: 16°C 28°C 1 01 99 2 24 20 3 20 19 4 07 4 5 18 17 6 d3 99 7 01 99 8 00 00 9 00 00 A 58 29 B 12...

Brian, Just seen your reply regarding the diagnostic function within the 8th gen. Thanks for this. My air conditioning i dont think is cooling properly, there is very little change in the air temperature when it is turned on. For comparison my sisters 7th gen, the air con is far cooler. I can...

Hello, On my car the back wheels are wearing on the inside (17 inch wheels), and the camber is out according to wheel alignment report, approx 1.38 degrees negative each side. What was the outcome with your car?

Hi, Do you have the guide for the 8th generation?

Got wheel alignment checked today, and all is good with the front wheels, no readjustment required. The rear wheels however are showing up with negative camber, about 1.3 degrees each side, the alignment shop say this inst adjustable. I wonder what would cause this to drift away from the...

Yes

Completed this job today,no hassle at all The one thing I also did was loosen the nut on the end of the driveshaft to let this back out of the hub, Otherwise I was pulling the cv joint out of the driveshaft end in the gearbox when forceing the strut down Just have to get steering alignment...

Hi Alex, Thanks for that, you done a great write up on the job. Do you know if honda supply just the ball joint to fit in the arm? Also on the genuine honda item, is there a circlip holding the old ball joint in the arm Im only recently after getting this car, so far am very happy with it. I...

Hello, The upper ball joint on front drivers side is gone, anyone replace one of these before. A quick google im seeing people replacing teh entire control arm, can the ball joint itself be replaced on its own. Also is it a job that is easy enough, or a lot of hassle when you go at it Thanks

I got the subframe lowered enough without having to lift the engine. Had to remove the rear engine mount and had an awful job getting one of the bolts out which holds the air con pump bracket to sump. Just counting time, i must have spent around 15-16 hours at this job, this is without a lift...

You were spot on when you said a world of pain! got it done in the end though

Hello, Thanks for replies, i have made a start on this job. I have managed to remove all bolts holding the sump on bar one of them, which is in the bracket which the air conditioning pump is held. i will have to modify a spanner to get this one out, the front cross member is limiting access to...

Hello, I went to change oil in an accord belonging to a family member, and the sump plug was covered in a mound of sealant, so didn't carry on with the job. I have got a sump, second hand as a new one isnt cheap. To me the job should be straight forward enough, however just said i would ask...