Search results

Hi, I've had my ictdi 2004 for about 5 years now, currently on 240,000. I have changed lots of normal wear and tear bits over the years. Noticed the engine while running fine is perhaps feeling the high mileage, looking at making it a bit more responsive. What could I change or do that could...

Well finally I get a leak, I know what's involved in replacing this and it's something I cannot attempt. Does anyone know the cost to replace this at honda or an independent. Anyone tried stop leak products. I'm not worried about the heat it's been blocked for 5 years anyway. Thanks

Removing and cleaning this on a pre-facelift accord, I have no idea how much build up is in there but do you think it's worth doing ? There's a good guide on cleaning this and replacing the gaskets. Looks straight forward just wondered if it's worth doing?

Hi does anyone know where to find the the OE number for a pre-facelift 2004 estate ctdi rear driver side caliper or the part number. Is there a book or manual that would have all of this Information thanks.

Hi and happy new year to you all, Does anyone know if annealing the injector washer will restore any imperfections, my one is blowing, took the washer out and it has a slight indent I guess the diesel is escaping at this part, will annealing restore this? I have new ordered one but won't be...

Hi everyone, the other day while driving I start to hear a clunking/knocking noise from the front end of my 2004 ictdi, possibly passenger side. The engine, braking and steering all seem fine, this may be made worse by going over bumps. I haven't had a good chance to look yet but will later...

Hi everyone, just looking for a little advice as I'm a noob but I like to try as much diy as I can. Managed to change both lower control arms the other day, following an online video, question is all bolts etc were tightened with the vehicle off the ground then lowered, is this ok or did it...

Hi guys, I have an 04 diesel tourer, does anyone happen to know the minimum mm that the front discs need to measure to pass the MOT? Thanks