TheHole
TAF Member
Hello all
This is a very simple and quick mod to give you footwell lighting.
first remove dash trim from under the steering wheel.
The remove the plastic kick guard above the pedal ***embly.
from here you should not have good view to under the steering wheel / the mass of connectors down there!
on the right hand side you will find a series of connectors:
Remove the one pictured:
then crimp in to the wire with the blue strip (pictured below)
Then get the connector directly on the left of that connector and crimp in to the green wire (ground)
(ignore the big red cable in the above photos thats for the amp in my boot!)
Once you have paired in to those wires you can run these to any 12v leds / applicable lights you want (the white one is + the green in the ground)
Re ***emble the lower dash and now attack the passanger side.
Undo the to 8mm nuts at the bottom of the glove box and remove the glove box.
straight infront of you on the left hand side you will see a few connectors again.
Pair in to this wire (with is +)
re insert that connector and get the other connector on the left hand side.
Again, pair in to the green wire here which is the ground.
again wire these to what ever you like and re ***emble.
Job done
This allows you to have independant footwell lighting for the front two doors.
I will update this again soon to include the rear, but i need more time to rip the car apart!
Adam
This is a very simple and quick mod to give you footwell lighting.
first remove dash trim from under the steering wheel.
The remove the plastic kick guard above the pedal ***embly.
from here you should not have good view to under the steering wheel / the mass of connectors down there!
on the right hand side you will find a series of connectors:
Remove the one pictured:
then crimp in to the wire with the blue strip (pictured below)
Then get the connector directly on the left of that connector and crimp in to the green wire (ground)
(ignore the big red cable in the above photos thats for the amp in my boot!)
Once you have paired in to those wires you can run these to any 12v leds / applicable lights you want (the white one is + the green in the ground)
Re ***emble the lower dash and now attack the passanger side.
Undo the to 8mm nuts at the bottom of the glove box and remove the glove box.
straight infront of you on the left hand side you will see a few connectors again.
Pair in to this wire (with is +)
re insert that connector and get the other connector on the left hand side.
Again, pair in to the green wire here which is the ground.
again wire these to what ever you like and re ***emble.
Job done
This allows you to have independant footwell lighting for the front two doors.
I will update this again soon to include the rear, but i need more time to rip the car apart!
Adam