Channel Hopper
Members
OK, bridged the Pins 3 and 4 on the VSA switch and tried again, no change.freddofrog said:The ESM says (VSA OFF Switch Test)
Remove the VSA OFF switch from the switch panel
Disconnect the VSA OFF switch 5P connector
Check for continuity between the VSA OFF switch 5P connector terminal No. 1 and No. 2. There should be continuity when the switch is pressed, and no continuity when the switch is released.
Check for continuity between the VSA OFF switch 5P connector terminal No. 3 and No. 4. There should be continuity at all times
I did download the manual from the dropbox site but have not had a chance as yet to see where the wiring diagram is. It would be good to know where the two wires run from/to in case there is a fusible link somewhere, and to determine why the switch may have failed in such a way.