Latest activity
-
Rryan14421 replied to the thread Water in spare wheel well (ES Tourer).I had the same issue on my saloon. A common fault after some Googling suggested it could be due to the seals on the tail light, or a...
-
-
This is gonna be long, so bear with me! it may seem over the past few months my contribution to the forum has reduced...that's because... -
What is the issue you’re trying to chase? I notice multiple threads from you recently. Yes it’s advisable to disconnect the battery... -
Júlio Rocha replied to the thread I-DTEC: MAF and MAP cleaning.Thank you. If I created several threads with the same subject, I apologize… :confused: It’s just for maintenance! Thank you once again...
-
F6HAD replied to the thread I-DTEC: MAF and MAP cleaning.What is the issue you’re trying to chase? I notice multiple threads from you recently. Yes it’s advisable to disconnect the battery...
-
Hello! Is it necessary to reset the ECU, by disconnecting the battery or removing a fuse, when we clean the MAF and MAP sensors? Some...
-
CChannel Hopper replied to the thread Strange engine behaviour after stalling.I can't recall the max rpm, but I could get up to slightly over 40MPH in top/fifth gear on a good day. Farhad suggestion of the TPS...
-
F6HAD replied to the thread Strange engine behaviour after stalling.Did you get any warning lights at all? Any flashing glow plug light for example? Did the vsa light appear even momentarily? I would...
-
Richard B replied to the thread Strange engine behaviour after stalling.Thanks for the suggestions. I thought Limp Mode in the Diesel Accord still allows up to 2000 rpm? Are there different limp modes... -
CChannel Hopper replied to the thread Strange engine behaviour after stalling.It sounds like a limp mode because it is. I had times when a code didn't flag up and switching off and restarting (three times ?) clears...
-
We've all occasionally stalled the engine, right? I did today, after a 1 hour drive, ending in stop-start urban traffic, I think I...
-
RRoger the Dodger replied to the thread Rear heat shield.Thank you for your prompt reply Sir. I recently sold a 2008 Estate and some of the rear suspension components still had part number...
-
Sstellamon replied to the thread Rear heat shield.I didn't but it would have made it easier. I have an ***ortment of wire brushes to fit into my cordless drill to remove the majority...
-
Hells bells ! I owned a Lancia with less corrosion.
-
RRoger the Dodger replied to the thread Rear heat shield.Any thoughts on how you are likely to 'tackle' the rust?
