Recent content by wookie

If it's only when reversing then it is probably characteristics of the car due to the engine mounts. (That is the official wording from Honda) There was a bulletin on this a few years ago.

Did you try blanking the egr off?

Pretty sure the 02 doesn't. I know my old 99 plate didn't. It didn't even have electric rear windows.

Sounds like the passenger window switch faulty. It's a multiplex unit hence the cost when you speak to Honda. I have seen these fail, and the trouble shooting says replace passenger switch if still doesn't work then replace drivers switch pack.

I don't think it's that badly priced considering Honda parts

Your local Honda dealer should be able to look it up for you, from memory it's called the discharge hose

One side of the bearing is a magnetic ring which is part of the seal if it gets damaged in any way it can put the light on.

New hub, unbolt bolt on. It's possible you damaged it while doing the sensor

Left rear pulsar failure is the magnetic ring on the wheel bearing damaged/faulty. basically you need a new wheel bearing. I had the exact same code last week at work.

Will have to be from the same model, they are not coded though so plug and play

It sounds like the nsf window switch is faulty, and possibly the osf as well. I have replaced a few now. The trouble shooting is pretty useless from what I remember basically substitute good known unit. If you can try one first before booking into a garage you could save some money.

Because with a trade card car bulbs are peanuts!!

Oh dear, have they given the car to the apprentice to look at? Surely clear the codes and start again. Then if the non related codes come back then there is further issues. If they've had the ignition on while troubleshooting and disconnected something else then that can throw a code. And as a...

You can buy the inner joint separately, this is the part that usually fails. When you strip the inner joint down you will see wear marks on the inner joint.

I'm only guessing why they are trying to justify their time. To remove cover will take time as rocker cover has to come off which means injectors will need to be removed.